SHOWTEC 42199 Guia do Utilizador descarregar pdf (Página 9)

Backside

Fig. 2

3) IEC Power In

4) Ground

5) Fuse 250V / 1A

6) Menu Buttons + LED display

7) DMX signal connector (IN) 3-pin

8) DMX signal connector (OUT) 3-pin

9) IEC Power Out

Installation

Remove all packing materials from the LED Light Bar 8. Check that all foam and plastic padding is

removed. Connect all cables.

Do not supply power before the whole system is set up and connected properly.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Control Modes

There are 6 modes for using the LED Light Bar 8: • Manual control (Static)

• Built-in Programs

• Macro Colors (Auto Run)

• Sound-controlled

• Master/Slave

• DMX512

One LED Light Bar 8 (Manual Control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the LED Light Bar 8 is not connected by a DMX-cable, it functions as a stand-alone device.

If device is set to , then the fixture can be manually controlled.

Please see page 14 for more information about manual control Mode.

One LED Light Bar 8 (Built-in Programs, Macro Colors)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the LED Light Bar 8 is not connected by a DMX-cable, it functions as a stand-alone device.

If device is set to or , then the fixture will play one of its built-in programs or

show one of its macro colors. Please see page 14 and 17 for more information about the built-in

programs or macro colors.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Sem comentários

SHOWTEC 42199 Guia do Utilizador Página 9