SHOWTEC 42199 Guia do Utilizador descarregar pdf (Página 10)

One LED Light Bar 8 (Sound-control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the LED Light Bar 8 is not connected by a DMX-cable, it functions as a stand-alone device.

Turn on the music. If device is set to (Audio) and you have pressed enter, then the fixture

will react to the beat of the music. Please see page 13 for more information about the built-in

programs.

Multiple LED Light Bars (Master/Slave control)

1. Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.

2. Plug the end of the electric mains power cord into a proper electric power supply socket.

3. Use a 3-p XLR cable to connect the LED Light Bar.

The pins:

1. Earth

2. Signal -

3. Signal +

4. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can

use the same functions on the master device as described on page 13-16 (Built-in Programs, Auto

Run, Static Color or Music control). This means on the master device you can set your desired

operation Mode and all slave devices will react the same as the master device.

Multiple LED Light Bars (Master/Slave control)

Fig. 3

Multiple LED Light Bars (DMX Control)

1. Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.

2. Plug the end of the electric mains power cord into a proper electric power supply socket.

3. Use a 3-p XLR cable to connect the LED Light Bar and other devices.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Sem comentários

SHOWTEC 42199 Guia do Utilizador Página 10